Stain Block Elite
Invisible penetrating stain blocking masonry sealer for DENSE SURFACES
Application Guide
IMPORTANT NOTE: Before use on a job, thoroughly test this product
in an inconspicuous area to assure performance and appearance. Use
only in well ventilated areas.
SURFACE PREPARATION:
All surfaces to be treated must be clean and free from dirt, moss,
mildew, laitance, efflorescence, and any other contaminate that may
interfere with the penetration or reaction of Stain Block Elite masonry
sealer to the applied surface. Remove all dirt, wax, oil, paint or
sealers with appropriate cleaner, chemical stripper or abrasive blasting.
If muriatic acid has been used the surface must be flushed with clean
water and neutralized with a pH neutralizer. After cleaning, allow
surface to dry 24 hours prior to sealer application. Allow new concrete
to cure for at least 14 days before application of sealer. Protect
greenery from over spray.
APPLICATION:
Stain Block Elite masonry sealer can be applied
with a sponge, brush, roller, or most types of spray equipment. On
dense surfaces one coat, applied to saturation, is all that is required to seal the surface which will assure long lasting protection. For small
areas, a pump-up garden sprayer is convenient. For large commercial
installations an airless spray system is recommended. Do not apply
Stain Block Elite masonry sealer during wet weather or when surface
temperature exceeds 90°F. Application to a damp surface or incompletely
cured concrete may cause a hazy appearance or loss of adhesion. Air
and surface temperature should be between 50° and 90°F for
24 hours following application. Additional gloss and protection are
available with added applications. After each coat perform “water
penetration test” (see below). Brush ................................... synthetic bristle brush. Roller ............................ "1/4" nap lambs wool
roller. Airless sprayer tip size ................... 0.013" - 0.015”
IMPORTANT NOTE: Over application and excess sealer should not be allowed to pool
or puddle. Wipe up any pools that are still standing after 5 minutes.
WATER PENETRATION TEST: Drop a small amount of water on the sealed surface. If water penetration
occurs or if water does not bead up on the surface, the application
additional sealer is required.
MAINTENANCE: Little maintenance is required except for sweeping the surface
of dirt and wiping up spills soon after occurrence. Perform “Water
Test" once a year. If test fails, reapply Stain Block Elite masonry
sealer .
CLEANUP: Water
SAFETY PRECAUTIONS: CAUTION: LIQUID CONTACT WITH EYE AND SKIN MAY CAUSE IRRITATION.
DO NOT INGEST. Contains NO solvents. Avoid contact with eyes and skin.
Wash hands thoroughly after using and before eating and smoking. If
spillage has occurred, absorb and dispose of according to local regulations
KEEP THIS PRODUCT OUT OF THE REACH OF CHILDREN.
FIRST AID: Should eye contact occur, flush with plenty of
water for at least 10 minutes and get medical attention if vision
is disturbed. For skin wash thoroughly with soap and water. If swallowed
get medical attention immediately. DO NOT induce vomiting.
|